Princeton Tec VIZZ RGB Instrucciones De Operacion Y Mantenimiento

VIZZ RGB
®
HEADLAMP
Operating and Maintenance Instructions
ENGLISH:
Battery Installation
- See Figure 1
• 3 AAA
• Alkaline (LR03) or Lithium
• Rechargeable NiCad or NiMH
Princeton Tec cares about the environment and
recommends recycling batteries. For more information
about battery recycling, please go to https://
batterysolutions.com
Observe proper battery polarity. Improper installation of
the batteries will damage the light and void the warranty.
!
WARNING
• Never mix fresh and used batteries.
• Never mix different battery brands or chemistry types.
• Always remove drained batteries immediately.
• Remove batteries during long periods of storage.
NOTE: Lithium batteries offer extended constant
brightness time, extreme cold weather performance,
and lighter weight. Rechargeable NiCad or NiMH
batteries may result in reduced brightness due to lower
nominal voltage.
The Vizz RGB battery compartment has a waterproof
seal. It is important to keep this seal free from dirt
and away from harsh chemicals in order to preserve
waterproof integrity. Inspect the seal every time
batteries are changed. If dirt is present, wipe gently with
a damp cotton swab and mild soap until dirt is removed.
Switch Operation - See Figure 2
From off:
Press 1x -
Press 2x -
-
Press 3x
Press 4x -
One Second Hold from any mode -
Press & Hold while in white mode -
Press 1x after more than 1 second
in any mode-
Five second hold -
From off, 5 second hold will lock light to prevent
accidental Activation and resulting battery drain.
Removal and replacement of batteries will also reset
Vizz RGB to unlocked state.
Troubleshooting
If the Vizz RGB fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper installation is confirmed.
• Check circuit board for water (the seal may have been
compromised by improper rear cover installation or
dirty seal). The light will resume normal operation
once the water is shaken or blown out and the light
is left open until completely dry. If the light has been
contaminated with salt water, flush the unit with fresh
water and dry as described above.
Figure 1 – Battery Replacement
1
Figure 2 – Switch Operation
Figure 3 – Performance
Modes
HIGH SPOT
LOW SPOT
RED
GREEN
BLUE
DISTANCE (m)
(ANSI FL-1 Standard)
Runtime is defined as the duration of time from the initial light output value—defined as 30 seconds after the
point the device is first turned on—using fresh batteries, until the light output reaches 10% of the initial value.
Reserve time is the duration of time from 10% of initial light output value down to 0.25 lux
USA Lifetime Warranty - International
10-YearWarranty
Due to International regulations, Princeton Tec's
lifetime warranty can only be offered to customers
in the USA. Princeton Tec offers a 10-year warranty
to our customers outside the USA. FULL WARRANTY
- Princeton Tec warrants this product to be free from
defects in workmanship and materials under normal
Red
use for as long as you own this product. This warranty
Green
covers all of the component parts of the product except
Blue
batteries. This warranty does not cover deterioration due
Off
to normal wear or damage due to misuse, alteration,
White
negligence, accidents, or unauthorized repair. Princeton
Dimming
Tec will repair or replace parts which are defective in
workmanship or materials. Your authorized Princeton
Off
Tec Dealer and Princeton Tec are the only facilities
Lockout/Unlock
authorized to repair the product. After (3) unsuccessful
attempts to repair the product, you have the right to
elect replacement of the product or a refund of the
purchase price less allowance for use of the product.
NO INCIDENTAL OR CONSEQUENTIAL DAMAGES
ARE INCLUDED IN THIS WARRANTY. (Some states do
not allow the exclusion or limitation of incidental or
consequential damages, so the above limitations or
exclusions may not apply to you.) This warranty gives
you specific legal rights, and you may also have other
rights which vary from state to state.
Princeton Tec reserves the right to change product
specifications without notice.
2
Press 1x:
Red
Press 2x:
Green
Press 3x:
Blue
Press 4x:
Off
Lumens Runtime Beam Pattern
550 2.5
40 33h
3 45h
5 55h
3 40h
0 5 20 25
3 4
1s hold in any mode:
White 80%
From white:
Hold:
Dimming
After 1s in any mode:
Press 1x from On:
Off
FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol A (BpA) a
chemical known to the State of California to cause birth
defects or other reproductive harm.
Return Policy
If your light fails to operate, follow these simple steps:
1. Check batteries. Replace if necessary.
2. To send your light in for repair or replacement, first
contact Princeton Tec customer service on
1-800-257-9080 to request an RMA number. Please
have your light model, date of purchase and a brief
description of the fault you are experiencing. No
warranty repairs will be accepted without an RMA
number.
3. Return the light without batteries to: Princeton Tec,
PO Box 8057 Trenton NJ 08650. Postage due and
freight collect items will not be accepted.
4. Upon receipt your light will be processed in about
two weeks. Please allow additional time for return
transportation from NJ.
Princeton Tec
PO Box 8057 ,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
© 2023 Princeton Tec
Press 5s:
Lock-Out
Press 5s from Lock:
Unlock
Reserve
70h
80h
45h
100h
40h
95