Maintenance; Cleaning The Optics - Woodley Vision V5000 Manual De Instrucciones

5.0 MAInTenAnCe

5.1 Microscopy environment
This microscope is recommended to be used in a clean, dry and shock free environment with a
temperature of 0-40°C and a maximum relative humidity of 85 % (non condensing). use a dehumidifier
if needed.
5.2 To think about when and after using the microscope
• The microscope should always be kept vertically when moving it and be careful so that no moving
parts, such as the eyepieces, fall out.
• never mishandle or impose unnecessary force on the microscope.
• never attempt to service the microscope yourself.
• After use, turn off the light immediately, cover the microscope with the included dust-cover, and keep
it in a dry and clean place.
5.3 electrical safety precautions
• Before plugging in the power supply, make sure that the supplying voltage of your region matches with
the operation voltage of the equipment and that the lamp switch is in off-position.
• users should observe all safety regulations of the region. The equipment has acquired the CE safety
label. however, users do have full responsibility to use this equipment safely.
5.4

Cleaning the optics

• If the optical parts need to be cleaned try first to: use compressed air.
• If that is not sufficient: use a soft lint-free piece of cloth with water and a mild detergent.
• As a final option: use the Microscope lens Cleaner (Product Code WD0384) available from Woodley
Equipment.
note: For regular maintenance and cleaning we recommend using our Microscope service Kit
(Product Code WD0383) which includes: lens Cleaning Fluid (WD0384), Air Duster (WD0385), Cotton
Applicators (WD0386), Microglide lubricant (WD0387), lint-free lens paper (WD0388) and illustrated
service instructions. All these products are also available individually
5.5 If you need to send the microscope to Woodley for maintenance, please use the original packaging.
Page 8