MSD GPR+ Guia De Inicio Rapido página 2

DESCRIPTION
GPR+ is a universal portable reader for RFID
microchips with the purpose of identifying
animals.
The device can read a wide range of technologies:
FDX-B ISO, HDX ISO, FDX-A (FECAVA), Trovan
and Avid encrypted. GPR+ can also read and
display the Microchip Temperature™ when
reading temperature sensing microchips*.
In addition to its microchip reading functions,
the GPR+ scanner can store up to 3000 IDs
in its internal memory, each associated with a
time/date stamp, which can be transmitted to a
personal computer via a USB cable or wirelessly
using Bluetooth®.
Bluetooth® indicator
Battery
level
indicator
ID code
The GPR+ is supplied with the Microchip
Management Software which enables user to
download the reader's memory, change the
scanner settings or update the GPR+ firmware. It
is available for download at
com with the complete User Manual and
Software User Guide.
1 Microchip Temperature™ range is from 33ºC (91.4ºF) to 43ºC
(109.4ºF). If the temperature is below or above this range, it will
display "TEMP BELOW RANGE" OR "TEMP ABOVE RANGE".
* for temperature sensing microchips sold by MSD Animal Health
and its affiliates
Memory level
(when enabled)
or temperature
information
www.destronfearing.
2
GETTING STARTED
GPR+ comes supplied with six AAA rechargeable
NiMH batteries which must be fully charged
prior to use, as diagram below (step 1 through 3).
If preferred, six standard AAA alkaline batteries
can also be used and should not be charged
(follow only step 1).
Step 1 – Remove retention screw
located on bottom back of GPR+.
Place batteries according to polarity
indicators. Replace lid and screw.
Step 2 – Remove USB plug and
attach cable to GPR+.
Step 3 – Plug the adaptor into
power outlet. The battery level icon
will flash while charging and stop
flashing when fully charged. A full
charge will take approximately 3 hours.
DO NOT MIX RECHARGEABLE AND
STANDARD BATTERIES.
DO NOT ATTEMPT TO CHARGE
STANDARD ALKALINE BATTERIES.
CHARGE THE BATTERIES INDOORS ONLY
AND BETWEEN 0°C AND 40°C.
To extend battery life, charge unit at least every
three months, if reader is unused.
3