HomeMatic IP HmIP-RGBW Manual De Instalacion Y Uso página 31

To add the device, please proceed as follows:
• Open the Homematic IP app on your smartphone.
Select the menu item "Add device".
•
• When the power supply is switched on, the actuator's pairing
mode is active for 3 minutes (fig. 11).
You can manually launch the pairing mode for another 3 minutes by
briefly pressing the system button (A) (fig. 11).
• Your device will automatically appear in the Homematic IP app.
• To confirm, enter the last four digits of the device number (SG-
TIN) in your app, or scan the QR code. The device number can be
found on the sticker supplied or attached to the device.
• Wait until pairing is completed.
If pairing was successful, the LED (A) lights up green. The device
•
is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• In the app, give the device a name and allocate it to a room.
5.4 Basic settings
The operating mode of the LED controller is set in the device settings of
the user interfaces (HmIP app and WebUI). This must be set according to
the intended use. The following options are available:
• 4 x Single LED strips (fig. 7)
• 1 x RGB (fig. 8)
• 1 x RGBW (fig. 9)
• 2 x Tunable White (fig. 10)
Start-up
31