Operation - Qlima PGP 113 Instrucciones De Uso

Step 10: pic. 12
•
Step 11: pic. 13
•

OPERATION

•
Please note:
-
-
-
-
•
•
•
Note:
-
-
•
•
LIGHTING INSTRUCTION
•
•
TO TURN ON THE HEATER
Check that the regulator seal is correctly fitted and able to fulfil its function.
a)
4
b)
50
Note : Do not cover the front side where the control knob is.
Install the knob to M4X6 screw. Hang the chain to the hole on the control
box assy and put the pothook of front panel to the holes of bottom plate.
Connect the gas hose and regulator after that connect the regulator to the
gas cylinder.
WARNING! Ensure the hose does not contact any high temperature surfaces,
or it may melt and leak causing a fire. After the cylinder is placed inside the
heater, secure the cylinder with block belt tightly.
Connect the gas hose to the gas connector. (pic. 14)
The gas hose is NOT included with the heater. Hose must be purchased sepa-
rately
Minimum / Maximum length gas hose: 60-80 cm
Screw connection (France G1/2) is fitted as standard
Hoses 8-13 mm. can be fitted as well. When required: use the multi country
connector supplied. Fitting of the multi country connector is described in the
separate manual supplied in with the included multi country kit. When using
the multi country connector: ALWAYS make sure to use hose clamps!
For gas hose with threaded connectors: bind 2 or more rounds of plumbing
tape around the gas pipe before connecting the gas hose for security.
Bind 2 or more rounds of Teflon plumbing tape around the gas burner inlet
connector and connect the gas pipe. Use a wrench to tighten the connection.
Connect the other end of your gas hose according to the mounting instruc-
tion as supplied with the gas hose and/or supplied with the gas regulator.
The gas hose is NOT included with the heater
The gas regulator is not included with the heater
Connect the regulator to the gas cylinder (not included) according to the
mounting instruction as supplied together with the gas regulator and/or the
gas cilinder
Put gas cylinder on the base.
Check and ensure that an AA battery is inside the ignition chamber. Use a
new battery so you are sure the battery is full of power.
Ensure that the '+' side of the battery is facing outside (so '+' faces towards
the user)
Open the valve on the gas supply cylinder.
Press and turn the variable control knob to PILOT position (counter-clockwise