Publicidad
Installation
• Make sure the waste bin is securely in place.
• Connect the electricity plug to any standard power socket
Operation
Press the power switch on the back of the shredder and ready light will illuminate
• Make sure the waste bin is fully inserted into the shredder housing or the machine will not operate
• Feed the paper/credit card into the appropriate slot and the machine will start automatically, and stop when shredding has
fi nished
• If you want to stop shredding or for emergency release - press & hold the reverse button
• After shredding, press the power button to turn off the shredder
Capacity
This Swordfi sh shredder will shred:
• up to 8 sheets of 80gsm paper with a max width of 220mm
• credit cards through the credit card slot in the middle of the paper feed opening
Continuous shredding should not last more than 3 minutes, after which the shredder should be allowed to cool down for 30
minutes before continuing. If the shredder is used continuously for more than 3 minutes, the shredder will automatically switch
itself off . After an auto power off , put the switch into the off position for 30 minutes before turning the shredder back on.
In case of a minor paper jam:
Grasp the excess paper from the top and pull it out as you press the reverse button.
In case of a major paper jam:
The shredder will automatically switch itself off . After an auto power off , put the switch into the off position for 30 minutes before
turning the shredder back on. Grasp the excess paper from the top and pull it out as you press the reverse button.
Oiling Instructions
• To ensure proper operation and function, periodic oiling of the cutting system is required. Failure to oil your cutting system
could result in reduced sheet capacity performance, excess noise, paper jams and possibly machine failure.
• Oil your cutters every time you empty the bin. (See opposite)
•
Use only oil designed for use in shredders! Never use fl ammable or aerosol lubricants.
•
Lubrication should always be done when the shredder is cold. Never add oil to a hot shredder.
•
On no account should any aerosol product be used on or near this machine, as the propellants may be fl ammable.
Warning
• Do not place fi ngers too close to the feed slot as serious injury may occur
• Always disconnect the power plug before cleaning a Swordfi sh shredder
• Repairs must be carried out by a specialist. There are no user-serviceable parts inside a Swordfi sh shredder. Unauthorised
attempts to service the machine will invalidate the warranty
• Keep the waste bin emptied so that the shredder output is not impeded.
• Swordfi sh shredders should only be used within the defi ned capacity
• Keep all loose articles of clothing, ties, jewellery, long hair or other loose objects away from opening
• Keep children away from the machine. This shredder is not a toy
• Do not pass paper clips or soft plastics through the shredder
• Shredders should be oiled on a regular basis and before any period of intensive shredding
• Lubrication should always be done when the shredder is cold. Never add oil to a hot shredder
•
Follow these operating instruction. Damage caused by misuse will not be covered by warranty
6
www.snopakebrands.com
Operating Instructions
Failure to do so can cause serious damage
Publicidad
