Orbegozo FO 6100 Manual De Instrucciones página 9

Idiomas disponibles

FO 6100 / FO 6200

The surface where the gas cooker will be installed must be flat and high temperature resistant.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or

mental capabilities or lack of experience and knowledge, unless they are supervised by a competent

person during its use.

Children should be supervised to ensure that they do not play with the appliance.

PRECAUTION: For safety reasons, never leave packaging materials (plastic bags, cardboard, polyethylene

etc.) within the reach of children.

The manufacturer declines all responsibility in case of bad installation, or inappropriate use of the

device.

If the valves open or close with difficulty, they should not be forced and technical assistance should be

called.

WARNING: We advise you to check that your appliance has been properly installed. It is also necessary

to have the appliance checked at least once a year to check the condition of the connection tube, taps,

etc.

The surface where the stove is to be installed must be flat and resist high temperatures.

CONNECTING THE GAS

In order to work, the stove must have:

1 bottle of gas (butane or propane), only bottled by Official Dealers, in accordance with the gas

indicated on the data plate.

1 pressure regulator approved and indicated on the data plate with following characteristics: 28-30

bar for butane and 37 mbar for propane.

1 flexible tube approved for gas, with a maximum length of 1.5 m.

2 screw clamps for the flexible tube.

Connect the flexible tube to the gas supply inlet on the stove regulator and to the gas bottle regulator,

ensuring the tightness by means of the 2 screw clamps.

Place the bottle on a stable surface and assemble the bottle regulator. Make sure that the flexible tube does

not come into contact with the stove and that it is not subject to any twisting forces. After opening the

regulator, check there is no gas leak by applying soapy water with a brush on the joint of the flexible tube

with the cooker and the regulator. The appearance of bubbles means there is a gas leak. NEVER USE A

FLAME TO DETECT GAS LEAKS.

The bottle replacement must be done far away from any source of flame.

IF YOU SMELL GAS:

Turn off the burner

Close the appliance gas supply (bottle tap)

Contact your gas supplier or specialized personnel.

Fo 6200