Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Malfunctions may occur when the four lights
blinking in turns.
OVERHEAT PROTECTION
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the power tool/battery
cool before turning the tool on again.
OVERDISCHARGE PROTECTION
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the tool
and charge the battery.
MAINTENANCE
WARNING:
Remove the battery pack before maintenance!
Wear protective gloves and clothing!
Always wear protective equipments such as
gloves and eye protections to reduce the risk of
injury when operating this unit.
Only perform repairs and maintenance work
according to these instructions! All further works
must be performed by a qualified specialist!
When servicing use only identical replacement
parts. Use of any other accessory or attachment
may increase the risk of injury.
WINDING THE CUTTING LINE
Remove the battery before replacing the spool.
Press both latches of the spool cover together and remove
the spool cover. Afterwards, remove the empty spool
(Fig.13).
EN - 14
The battery is at 25%
capacity and requires
charging soon.
The battery is less
than 5% capacity
and requires charging
immediately.
Slide one end of the cutting line approx.02-04in (5-10mm)
into the hole for line wind-up in the spool (Fig.14).
Wind up the cutting line uniformly and tightly following the
direction indicated by the arrow on spool (Fig.15).
Slide the other end of the cutting line through the hole for
line guiding in the trimmer head (Fig.13).
Mount the spool back into the trimmer head and straighten
(Fig.13).
NOTE:
Only use cutting line consistent with "SPECIFICATION" for
replacement.
CLEANING
Switch the product off, pull out the battery pack from the
product.
Use a small brush to clean the outside of the unit. Do not
use strong detergents. Household cleaners that contain
aromatic oils such as pine and lemon, and solvents such as
kerosene, can damage plastic. Wipe off any moisture with
a soft cloth.
NOTE:
If the trimmer head is blocked by foreign objects during
operation, stop the product, wait till the product stops
entirely, then remove the foreign objects and clean the
trimmer head. Clean moving parts may result in hazardous
injury.
TRANSPORT
• Clean the product as described above.
• Always carry the product by its handle.
• Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
• Secure the product to prevent it from slipping or falling
over, damage or injury.
STORAGE
• Clean the product as described above.
• Store the product and its accessories in a dark, dry, frost-
free, well-ventilated place.
• Always store the product in a place that is inaccessible to
children. The ideal storage temperature is between
50°F(10°C) and 86°F(30°C).
• We recommend using the original package for storage or
covering the product with a suitable cloth or enclosure to
protect it against dust.
WWW.SENIXTOOLS.COM
Publicidad
