Publicidad
Idiomas disponibles
Idiomas disponibles
Always unplug the power cord before performing any adjustments, maintenance or repairs to your electric blower
vac.
SYMPTOM
Unit will not blow
1. Bag full
or mulch
2. Blocked tube
3. Blocked impeller
4. Dirty bag
5. Torn bag
6. Bag unzipped
7. Unit unplugged
Unit will not start
1. Unit is unplugged
2. Power/speed switch is in the
OFF (0) position.
3. Defective power switch.
4. Vac tubes are not correctly
installed.
5. Intake gate/cover is not closed.
6. House circuit may have tripped.
As the equipment owner, you are responsible for the performance of the required maintenance listed in the
Maintenance section. It is recommended that you retain all receipts covering maintenance on your equipment.
degrade performance, cause irreversible engine damage and/or void your warranty.
14
TROUBLESHOOTING
POSSIBLE CAUSE
RECOMMENDED ACTIONS
1. Empty the bag.
2. Clear the blockage.
3. Clear the blockage.
4. Clean the bag.
5. Replace the bag.
6. Zip up the bag.
7. Plug into an outlet or an extension cord.
1. Check cord to make sure it is plugged into an
electrical outlet.
2. Slide the power switch to the ON (1) position
3. Contact Senix customer service at 1-800-261-3981.
4. Check vac tubes and ensure that they are correctly
installed to allow the switch to be engaged.
5. Ensure that gate/cover is fully closed and locked.
6. Check wall circuit breaker panel and reset if
necessary.
WWW.SENIXTOOLS.COM
Publicidad
