Publicidad
Idiomas disponibles
Idiomas disponibles
INFANT CAR SEAT
INFANT CAR SEAT (Sold separately)
WARNING:
sliding out, always use the Infant Car Seat harness.
ATTENTION:
CS01 EZ-Lift, CS02 EZ-Lift PLUS and CS03 EZ-Lift PRO Infant
Car Seats must attach to the module of the strollers front seat. These models
require bumper bar
and seat back adjustment to the most reclined position.
NOTE: To make seat position adjustments refer to step 9.
Infant car seat sold separately
(visit babytrend.com for compatibilty chart)
CS01 EZ-Lift, CS02 EZ-Lift PLUS and
CS03 EZ-Lift PRO Infant Car Seats
CAR SEATS MODULE
CONNECTION
17)
•
Close the canopy as
described in the canopy
section (step 8).
• Align the car seat module to
the inner frame connectors.
Carefully rest the car seats
lower rear against the angle
point of the tray. Latch the
module into the stroller
frame. Press down firmly for the
click. ALWAYS ensure that the car
seat is properly connected and
locked onto the stroller before each
use by lifting up on the car seat
handle (Fig. 17a).
15
15
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
INFANT CAR SEAT
Avoid serious injury from falling or
"Click"
Fig. 17a
Removing the car seat:
•
NOTE: Set handle to the carry position (Fig. 17b). Squeeze the release
handle located at the Top-rear of the car seat and lift away from the stroller
(Fig. 17c).
Fig. 17b
Angle point
INFANT CAR SEAT
Press
Fig. 17c
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
16
16
Publicidad
