General Information - A.E.B. AEB2010 Manual Instrucciones De Montaje

General information
Where to install the control unit:
- FAR from any WATER LEAKAGE
- FAR from EXCESSIVE HEAT SOURCES (such as exhaust manifolds).
- FAR from HIGH-VOLTAGE CABLES.
Create efficient electrical connections without using any "POWER TAPS".
Properly insulated soldering is the most effective type of electrical connection.
Advise the customer that if the GAS system fuse burns, the connections of the
devices to which it is connected will be restored. It is strongly recommended
not to replace the fuse with another one with a higher amperage rating since
it may cause irreparable damage.
Do not open the Control Unit box for any reason, especially when the engine is running
or the key is in the ignition, to avoid irreparable damage.
A.E.B. will not be held responsible for damage to property or injuries to persons
if unauthorised personnel tamper with its devices; such tampering will also
invalidate the WARRANTY.
How to install the Control Unit
INCORRECT
INSTALLATION
IsAeb2010-0 Rev. 181208-0
English
INCORRECT CORRECT
INSTALLATION INSTALLATION
11-26