Alpina 871125238005 Manual De Instrucciones página 8

overheating. You must ensure that the air inlet and
outlet openings (2 and 5) are always unobstructed.
Do not install the appliance immediately below a
•
socket-outlet.
Assembly
Attaching the feet (refer to Fig. B):
1. Lay the convector heater carefully on its side.
2. Place the feet (4) under the convector heater in such a way that the
screw holes are correctly aligned.
3. Tighten the screws (4) until they are hand-tight. The feet (7) should
now be securely attached. Note: When deciding on the position of the
appliance please refer to the safety advice above and the information
in the section "Bringing the appliance into use".
Operation
Before use
Before using the device for the first time, check that the
mains voltage corresponds with that indicated on the device.
Also check that your electrical mains system has adequate
capacity for the output indicated on the device.
Make sure that the mains lead does not present a trip
hazard. Always direct the mains lead away from the rear of
the device.
Protect the mains lead from sharp edges, pressure and hot
surfaces.