Flex TL 4000 18.0/230 Instrucciones De Funcionamiento página 16

Overview (see figure A)
The numbering of the product features refers
to the illustration of the machine on the
graphics page.
1 On/off switch
2 Hooks
3 Hinges
4 Battery-pack/light-holder interface
5 Light-holder
6 Light release button
7 Light holder angle adjustment knob
8 USB port
9 Power-indicator button
10 On/off switch
11 Power indicator
12 Carrying handle
13 Power bay
14 Legs
15 Main light
16 Auxiliary lights
17 Lens transparent cover
18 Upper extension tube
19 Upper clamp
20 Lower extension tube
21 Lower clamp
22 Center pole
23 Bracket
24 Base
25 Light module
26 Tripod
27 Tripod release switch
Operating instructions
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power
tool
Unpack the cordless tripod light and check
that here are no missing or damaged parts.
16
NOTE
The batteries are not fully charged on delivery.
Prior to initial operation, charge the batteries
fully. Refer to the charger operating manual.
Inserting/replacing the battery
The battery can be attached directly to the
light module 25 or to the power bay 13 on
the tripod.
■ Press the charged battery into the power
tool until it clicks into place (see figure B &C).
■ To remove, press the release button and
pull out the battery (see figure D).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short
circuit the contacts, explosion and fire hazard!
Using extension cord
CAUTION!
The extension cord and a battery cannot be
used at the same time.
Remove the battery from the power bay.
Connect a suitable power cord (sold
separately) to the AC power inlet located in
the power bay 13.
To attach/detach the light module
to the tripod
WARNING!
Before attaching the light module 25 to the
tripod, please make sure the tripod legs 14
are fully expanded and secured firmly in the
locked position.
■ To attach: slide the light module 25 onto
the holder 5 (see figure E).
■ To detach: Press the light release buttons
6 inward to release the light module. Pull
the light module out and remove it from the
holder (see figure F).
To pivot the light holder
The light holder 5 can be pivoted 0-270° to
direct the light at a desired spot.
■ Rotate the angle adjustment knob 7
counterclockwise to the position marked
with .
■ Adjust the holder to a desired angle.
■ Rotate the knob clockwise to the position
marked with
figure G).
TL 4000 18.0/230
to lock the holder (see