Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Sanding Sheet
• To install the sanding sheet, release the clamps on both
sides of the sander.
• Set one end of the sanding sheet under one of the
clamps and secure. Pull the other end so it stays uniformly
onto the base.
• Verify the orifices (if any) match those in the base. Then
adjust the other side.
• The sheet must be perfectly fastened; otherwise there
could be excessive wear in the base.
Do not keep on using the tool if the
CAUTION
sanding sheet is worn or damaged.
Dust extraction with vacuum cleaner
• Before connecting the tool to the power, place the
vacuum cleaner adapter in the dust extraction duct.
• Connect the hose or extension tube of the vacuum
cleaner to the adapter.
Sander Operation
• Turn on the sander before setting it on the work piece. Hold
it with both hands, one in the handle, the other in front
handle.
• Keep the sander base parallel to the work piece surface.
• Press downwards making circular movements and
verifying the entire sander base is supported on the work
piece.
• Use moderate pressure. Do not force the sander. Run in
at a moderate speed. Overheating may occur if too much
pressure is applied. The motor will run slow leading to
inefficient sanding and damage to the motor.
• If after sanding you see marks on the work piece surface
sand again using a sanding sheet with coarser grain to
eliminate the marks. To finish the sanding operations,
replace back the previous sanding sheet. Replace the worn
sheet with a new one.
• Do not wear out the sanding sheet completely. Replace
before starts wearing out.
6
ENGLISH
Start Up
Start Up and Operation Control
• Intermittent Operation:
Connect the plug into the power outlet.
To turn on the tool, press switch (A).
To turn off the tool, just release the switch.
• Continuous Operation:
Connect the plug into the power outlet.
Press the switch (A) and block it pushing the continuous
use button (B).
To stop its function, press the switch and then release it.
Do not turn on the tool when the sanding
CAUTION
sheet surface is onto the work piece.
Before turning off the tool move it away
CAUTION
from the work piece.
B
A
Publicidad
