Publicidad
Idiomas disponibles
Idiomas disponibles
ILM Tag
Technical Data
Specifications
Specification
Frequency range, UWB
Transmitting power, UWB
Specifications
Scanner
Classification
Wave length
Maximum power output
Beam divergence
Radio Module
Antenna
Highest peak antenna gain
Conducted maximum output
power density
Frequency range
Declarations
EU DECLARATION OF CONFORMITY
We, Atlas Copco Industrial Technique AB, SE-105 23
STOCKHOLM SWEDEN, declare under our sole responsi-
bility that the product (with name, type and serial number,
see front page) is in conformity with the following Direc-
tive(s):
2011/65/EU (RoHS),2015/863/EU (RoHS amendment),
2014/53/EU (RED)
Harmonized standards applied:
EN 301 489-33 V2.2.0, EN 301489-1 V2.2.0, EN 302 065-2
V2.1.1, EN 62368-1:2014
Authorities can request relevant technical information from:
Aleksandra Duric, Product Compliance Manager, Atlas
Copco Industrial Technique AB, SE-105 23 Stockholm Swe-
den
Stockholm, 2 May 2022
Carl von Schantz, Managing Director
Signature of issuer
5500 MHz - 7500 MHz
-10.21 dBm
Class 2 laser
630 - 665 Nm
1.7 mW
47º horizontally, 30º verti-
cally
UWB chip antenna
0.8 dBi at 6.5 GHz
< -41 dBm/MHz (RMS)
6.25 – 6.75 GHz (Channel 5)
© Atlas Copco Industrial Technique AB - 9846 0337 00
WEEE
Information concerning Waste of Electrical and Electronic
Equipment (WEEE):
This product and its information, meets the requirements of
the WEEE directive/regulations (2012/19/EU), and must be
handled in compliance with the directive/regulations.
The product is marked with the following symbol:
Products marked with a crossed-out wheeled bin symbol and
a single black bar underneath, contain parts that must be han-
dled in compliance with the WEEE directive/regulations. The
entire product, or the WEEE parts, can be sent to your "Cus-
tomer Center" for handling.
FCC and ISED Compliance Statement
This device complies with part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) This de-
vice may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
FCC Responsible party:
Name: Tim Copacia
Position: Product Manager
Address: 3301 Cross Creek Parkway
MI 483 26 Auburn Hills
United States
Mobile: +1 5862020902
Email: tim.copacia@atlascopco.com
The device is only in compliance if no changes or modifica-
tions are made to the device. The antenna is fixed to the de-
vice and no change in antenna or fixation of the antenna is
acceptable and such modification is considered to violate the
Compliance Statement.
Safety Information
3
Publicidad
