Kicker CompVX Serie Manual Del Propietário página 5

Installation
Wiring Configuration
CompVX-Series subwoofers are made with
dual 2Ω or 4Ω voice coils. Both coils must
be connected to a source of amplification.
The Dual 2Ω will provide a 1Ω load wired in
parallel or 4Ω load wired in series. The Dual
4Ω will provide a 2Ω load wired in parallel or
8Ω load wired in series. Make sure your
source unit or amplifier is rated at the
correct ohm load for operation.
The speaker wire should be kept away
from sharp edges and avoid the possibility
of getting pinched by the trunk. If a factory
hole and grommet do not exist or are
inaccessible, you must drill a hole through
which to run the wire. Be careful not to drill
into other wiring or existing mechanisms.
Any time a wire is run through a hole, it
is necessary to insert a rubber or plastic
grommet to protect the wire from damage.
English 5