Publicidad
Idiomas disponibles
Idiomas disponibles
NEVER LEAVE THE HEATER UNATTENDED WHILE OPERATING!
NEVER LEAVE THE HEATER UNATTENDED WHILE OPERATING!
NEVER LEAVE THE HEATER UNATTENDED WHILE OPERATING!
7.
Turn the POWER KNOB to OFF and
unplug the heater when finished using.
THERMOSTAT KNOB
POWER
Temperature Control
KNOB
NOTICE: When the heat function is used for
the first time, a slight order may be present.
This is normal and should not occur again
unless the heater is not used for an extended
period of time.
NOTICE: It is normal for the heater to cycle
ON and OFF as it maintains the preset
temperature. To prevent the unit from cycling,
you need to change the thermostat setting.
MAINTENANCE
1.
Turn the POWER OFF.
2.
Unplug the unit and let it cool
completely.
3.
To keep the heater clean, the outer
shell may be cleaned with a soft,
damp cloth. A mild detergent can be
used if necessary.
4.
After cleaning, dry the unit with a
soft cloth.
5.
Wait until the unit is completely dry
before use.
WARNING:
•
DO NOT let liquid enter the
heater.
•
DO NOT use alcohol, gasoline,
abrasive powders, furniture
polish, or rough brushes to
clean the heater. This may cause
damage or deterioration to the
surface of the heater.
•
DO NOT immerse the heater in
water.
Mr. Heater Electric Heater
STORAGE
Store the heater in a cool, dry location
when not in use. To prevent dust and
dirt build-up, use the original packaging
to repack the unit.
TROUBLESHOOTING
If the heater will not operate, please
check the following:
1.
Check if the power cord is plugged
into an electrical outlet. If not, plug
in unit to appropriate outlet.
2.
Check if electricity to the outlet is
working.
3.
Ensure power is turned to ON
position.
4.
Make sure heater is placed on a
flat solid surface.
5.
See SAFETY FEATURES section for
additional information.
6.
Turn the THERMOSTAT KNOB
clockwise. The heater only works
when the set temperature is higher
than room temperature.
NOTICE: The product is equipped with an
overheat safety feature protector which will
switch off the heater in case of accidental
over heating (ex. Obstruction of air intake
and outlet grills, motor turning slowly or not
at all).
NOTICE: It is normal for the heater to cycle
ON and OFF as it maintains the preset
temperature. To prevent the unit from
cycling, you need to change the thermostat
setting.
6
Operating Instructions and Owner's Manual
Publicidad
