Philips Sonicare DiamondClean 9000 Serie Manual De Instrucciones página 19

Charging
The battery indicator shows the battery status when you
complete the 2-minute brushing session, when you pause
the toothbrush, or while it is charging.
Note: It can take up to 24 hours to fully charge the
battery before first use, but you can use the Philips
Sonicare toothbrush before it is fully charged.
Charging on charging base
1 Plug the cord of the charging base into an electrical
outlet.
2 Place the charging stand or the charging glass on the
charging base.
3 Place the handle on the charging stand or in the
charging glass.
- The battery indicator lights up and the handle
beeps twice. This indicates the toothbrush is
charging.
4 The charger will charge your toothbrush until it is fully
charged.
The handle is charging when the battery indicator is
flashing. When the handle is fully charged, the battery
indicator lights up for 30 seconds and then switches off.
Charging with the travel case
Note: Accessories included may vary based on the model
purchased.
1 Take the USB cable from the bottom of the charging
travel case.
2 Connect the charging travel case via the USB cable to
5V DC input power either from:
- The USB adapter provided
- a UL-listed or certified to ANSI/UL 60950-1
personal computer's standard USB connector or,
- a UL-listed or certified to ANSI/UL 60950-1 LPS
power supply with USB output port or,
- a UL-listed or certified 1310 Class 2 power supply.
19
English