Operation - Festool DOMINO XL DF 700 EQ Manual De Instrucciones

Setting stop pins
The stop pins on the front of the fence are used to
register the tool against the edge of the workpiece.
This provides rapid and precise placement of the
tool on the workpiece.
Six stop pins [9-2] are available on the stop side of
the DOMINO joining machine.
Stop pins that are not required can be individually
engaged by exerting overpressure and released us-
ing the button [9-1].
9-2
50 mm
37 mm
20 mm
1 2 3
A
B
C
These serve as spacers to the cutter centre and can
be inserted at different locations - see image [9]:
A Three possible spacings to a supply side (1 -
2 - 3)
B Two dowel holes beside each other from a
supply side (1 - 3)
C Two dowel holes by changing the workpiece,
e.g. for cross-section cut.
Please observe all mentioned safety infor-
mations and the following rules when work-
ing:
– Always secure the workpiece in such a manner
that it cannot move while being processed.
14
9-1
3 2 1
Widening the contact surface
The contact surface widening device [10-1] can be
used to enlarge the contact surface when routing
on the workpiece edge, thus allowing safer guid-
ance of the machine.

Secure the contact surface widening device us-
ing the two screws [10-2] on the threaded holes
[10-3] of the guide frame.
The contact surfaces of the contact surface wid-
ening device [10-5] and the table [10-4] must
be level.
10
10-1 10-2

Operation

– Always hold the machine with two hands on the
handles [1-3] when performing work. This re-
duces the risk of injury and is a prerequisite for
precise work.
10-3
10-4
10-5