20-7324
IMPORTANT SAFEGUARDS
1. Do not connect the fan to just any power point; only install it on the ceiling.
2. The minimum distance between the fan blades and the floor must be 7.55 feet.
If a hook is used to hang the fan, its maximum weight capacity has to be 220lbs.
3. Make sure you install a disconnecting switch for all pins with contact separation of at
least 3 mm between pins in the electrical supply wiring for the ceiling fan.
4. Disconnect the fan from the mains power before mounting or repairing it.
5. The electrical wiring must be in compliance with national electrical regulations.
6. The cable must be properly earthed in order to avoid any risk of electrocution.
7. Never install the fan in a room with a high degree of humidity or which is damp.
8. Take special care when you are close to the fan blades.
9. If the supply cord is damaged it must be repaired by the Authorized Service Agent.
10. This appliance must be installed following the national regulations for electrical
installations.
11. This appliance is only designer for to be used in habitual places (Don't use in wet place)
12. The appliance isn't destined for the use of children or person with physical or mental
problems and without experience nor knowledge; unless they make it down control of
a responsible or professional for the use of the appliance.
13. WARNING: In order to ensure your children's safety, please keep all packaging (plastic
bags, boxes, polystyrene etc.) out of their reach.
14. Important: always turn off the electricity supply to the circuit-breaker during
installation or maintenance. We recommend you to remove the fuse or turn off the
circuit-breaker connector when handling (Just switching it off is not enough).
WARNING
This fan must only be installed by somebody knowledgeable about working with
electricity.
SPECIFICATIONS
MODEL
RPM
165 min
20-7324
WATTS
1
60W
VOLTS
FREQUENCY
50 Hz
120V
ENGLISH
7