MAGICKWOODS Elements 31322 Instrucciones De Montaje página 2

WARNINGS & CAUTIONS
WARNING:
Two people are required for safe installation. Take extra precautionary
measures to ensure a secure grip on the vanity base when lifting.
CARE & MAINTENANCE
• To maintain the beauty of the furniture finish, avoid placing the vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by installing away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away any water or liquid spills on the vanity base immediately with a clean, soft and dry cloth.
INSTALLATION
Model 31325 shown in illustrations
1: Removing old vanity (if applicable): 1) Turn off the water supply and take the drain out. 2) Disconnect the supply lines from
the faucet. 3) Remove the old vanity top and vanity. NOTE: If the new vanity is not installed immediately, temporarily stuff
a rag into the drain pipe.
2: Using a level, locate any uneven floor and/or wall areas where your
vanity will be installed. Unevenness can cause your vanity to become
misaligned resulting in twisting of the cabinet. Repair any uneven
areas by reducing high spots or shimming low spots.
3: 1) Place the vanity in the desired position taking into account the
location of your plumbing. 2) Ensure the vanity is level front to
back and at both sides.
4: Secure the vanity to the wall by inserting (x 2) #8 x 2" screws
(B - not included) through the back rail of the vanity. Figure 1.
NOTE: It is recommended that the vanity be installed to at least one
wall stud. If you are unable to locate wall studs, it is recommended
that you use wall anchors (C - not included) to secure the vanity.
5: Install the hardware, vanity top, faucet and drain (each not included)
as per the instruction sheets provided with those items and ensure
that there is no leakage.
TROUBLESHOOTING
Problem:
1) Vanity doors or drawers rub
against another surface.
2) There is an uneven gap between
the doors or drawers and cabinet.
Side adjustment:
Using a Phillips screwdriver, rotate screw (1)
clockwise to move the door left and
counter-clockwise to move the door right.
Moves the door up to 2 mm.
Possible Cause:
Floor or vanity is not level.
Depth adjustment:
Using a Phillips screwdriver, rotate screw (2)
clockwise to move the door forward and counter-
clockwise to move the door backwards. Moves the
door up to 2 mm.
Figure 2 - Adjusting Hinges
CAUTION:
The bathroom floor and wall must be finished prior to
installation of the vanity base.
Figure 1
Corrective Action:
1) Use a shim to ensure the vanity is level.
2) Adjust the door hinges or drawer slides.
Figures 2 & 3.
Height adjustment:
Using a Phillips screwdriver, rotate screw
(3) clockwise to move the door upward and
counter-clockwise to move the door
downward. Moves the door up to 2 mm.