Publicidad
GB
Introduction:
Dear customer,
Thank you very much for purchasing this metal cabinet, and we hope it meets your requirements� To ensure
your safety and avoid mistakes during assembly, please follow all the steps in these instructions�
Maintenance:
Clean the cabinet with a damp cloth and mild cleaning agent� Never use cleaning agents that contain solvents
or are alkaline or acidic because this can cause damage�
Environmental protection:
Please take into account that the packaging materials as well as the article and replacement parts are recyc-
lable materials�
We would therefore like to ask that you support us with your active contribution to environmental protection
and dispose of the packaging and this article at the recycling collection centre at the end of its service life�
Tools needed:
Screwdriver PH2 (ca� 25 cm long)
Note:
!
Please do not install a shelf directly at the height of the door lock!
Due to the design of the metal cabinet, the lock cannot then be locked�
!
Please keep these assembly instructions in a safe place for future reference� Only pass on the
cabinet together with these assembly instructions�
!
Pieces of furniture can tip over and cause serious or life-threatening injuries� Please fasten the
cabinet with the enclosed fastening material� Please pay attention to the condition of your wall
during installation� If the supplied fastening material is not suitable for your wall, you can obtain
suitable fastening material from your DIY store�
Please only use fastening material that is suitable for the wall�
!
Before assembly, please check whether all parts listed below are present in the specified quantity.
8
107561 - 12 / 22
Publicidad
