Publicidad
Idiomas disponibles
Idiomas disponibles
Finishing the Installation
Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until
it locks in place at the narrow section of the key
holes. (Fig. 10)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure
by tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the hanging bracket properly
sits in the groove in the hanger ball before attaching
the canopy to the bracket by turning the housing until
it drops into place.
Figure 10
Blade holder ring
Blade
Step 4. Attach the blades to the blade holder ring.
(Figure 11)
Blade screw
Step 5. Attach the blade screws and tighten them.
Repeat this step for the 2 remaining blades.
Tighten the screws securely. (Figure 12)
Mounting
screw
Figure 11
Step 6. Remove one of the mounting screws on
mounting plate of motor assembly, then loosen
the other two. (Figure 13)
Figure 12
Figure 13
Switch housing
Figure 14
6.
Publicidad
