WISENT DUPLEX WORKSTATION Manual De Instrucciones página 35

• When using this product in work plat-
form mode or workbench mode, place
objects in the centre of the work plat-
form. If you place objects on the corners
of the work platform, there is a risk of
the platform falling over.
• If you want to lengthen or shorten the
legs, do not use excessive force, other-
wise the product may be damaged.
• Before using the product, make sure
that all legs are secured in the correct
position and that the latches above the
top plate are firmly closed.
• Do not use this product for any purpose
other than that described here.
• Always check the workstation for dam-
age before use.
• When using power tools, please read
the respective operating instructions
carefully. Always wear protective gog-
gles.
• Caution! If workpieces protrude – dan-
ger of tipping over!
Parts description
► Overview – p. 2
1. Multifunction table
2. Fastening lug
3. Supporting foot (foldable and extenda-
ble)
4. Foldable holder
5. Spring pin
6. Carrying handle
7. Spring button
8. Release button
Scope of delivery
Check the scope of delivery for complete-
ness and make sure the product and all
parts are in perfect condition immediately
after unpacking.
29386909
Assembly
CAUTION! Risk of cuts! Every
effort has been made to avoid
sharp edges on the components.
Nevertheless, be careful to avoid
injury during assembly.
Note: For illustrations, see
► Assembly – p. 3
Use
Note: For illustrations, see
► Operation – p. 5
Conversion from one mode to an-
other
Workbench mode
► p. 5, fig. 1
– Release the lock from the pair of wider
legs and turn them outwards. Then
release the lock from the pair of nar-
rower legs and turn them outwards.
Note: You must proceed in the pre-
scribed order, otherwise the legs
cannot be folded out.
► p. 6, fig. 2
– Pull out each leg and press on the hinge
until it locks into place.
► p. 6, fig. 3
– Turn the product over. Press the pin on
each leg, then pull each leg out until the
pin engages again.
NOTICE! Risk of damage to the
device! Make sure that each pin is
re-engaged before using the prod-
uct. Failure to do so could result in
a shortened leg if used.
Workbench mode to work platform
mode
► p. 7, fig. 4
– Press the pin on each leg and then slide
each leg in to the desired length.
► p. 7, fig. 5
GB
English
35