Skil STZ6307 Manual Del Propietário

Zero Clearance Insert
This zero clearance insert is designed specifically for use only
WARNING
with SKIL TS6307-00 table saw.
Read the table saw manual for use of this accessory with the
WARNING
saw.
NOTICE: This accessory is for 90° cuts only. Do not use it for bevel cuts.
1. Disconnect the saw from power source.
2. Remove the barrier guard assembly, the anti-kickback device, and the existing
table insert from the saw as instructed in the saw manual.
3. Place the riving knife to its lowest position and lock it in place.
The riving knife should be adjusted to and locked in the lowest
WARNING
position when making the initial cut in the zero clearance insert.
4. Lower the blade completely below the table surface.
5. Place the zero clearance insert in the table opening as shown in Fig. 1.
Fig. 1
Zero
clearance
insert
For Customer Service
1-877-SKIL-999
Pour le service à la clientèle
Servicio al cliente
Owner's Manual
6. Use the mounting holes of the zero clearance insert to drill four holes Ø1/8–9/64
inch (3.2–3.5 mm) in the supports for the insert plate as shown in Fig. 2.
Fig. 2
Model: STZ6307
7. Use a Philips head screwdriver to secure the zero clearance insert in place with
the four (4) included #8x3/8" self-tapping mounting screws as shown in Fig. 3.
Fig. 3
8. Connect the saw to a power source.
9. Turn the saw on and slowly raise the blade as high as it will go until the blade
cuts completely through the insert to reach the rear slot opening (Fig. 4).
Fig. 4
Rear slot opening
10. Disconnect the saw from power source.
11. Level the zero clearance insert:
a. The zero clearance insert should be flush* with the saw table surface.
b. Place a straight edge (such as the metal ruler from a combination square)
across the saw table and the insert – the surfaces should be at the same
level (Fig. 5).
* The front edge of the insert may be below the saw table by the thickness of
a piece of paper folded twice. Place the folded paper between the insert and
straight edge to check. The rear edge may be above the saw table by the
same amount.
c. If adjustment is necessary, use a 2.5mm hex wrench (not included) to adjust
four (4) leveling screws (Fig. 5).
www.skil.com
OR
Mounting
holes
Mounting
screws
Fig. 5
Rear edge
Leveling
screws
Front edge
12. Remove the zero clearance insert. Raise the riving knife and reattach the barrier
guard assembly and the anti-kickback device as instructed in the saw manual.
13. Reinstall the zero clearance insert.
An improperly leveled insert can result in binding which could
WARNING
result in personal injury. Verify adjustments by making a dry cut
before using the saw.
Never operate the saw without the proper insert in place. Use the
WARNING
saw insert when sawing and the dado insert when using a dado
set.
© Chervon North America, 1203 E. Warrenville Rd, Naperville, IL 60563.