MORDOMUS TRUE IOT iWL68 Manual De Instrucciones

iWL68
EN
iWL68 – Wi-Fi 6 ch input, 8 ch output
open-collector ON/OFF
Features:
• 8 open-collector outputs.
•
6 digital inputs;
• reads 3 types of clicks;
• reads security equipment (PIR, Gas, Fire detectors);
•
reads status switches (open/ closed);
• reads S0 impulse output of meters (3 input);
• DIN Rail Distribution Board mounting.
Applications:
• Relay drive for illumination, switching of sockets, heating, boilers,
motors, lighting, switching of loads in general.
•
Reading of push-buttons, switches, detectors and meters with S0
interface.
iWL68
https://www.mordomus
.com/mordomus/docs/
wifi/iWL68.pdf
Electrical specifications:
Supply Voltage: 15VDC;
Consumption: 200mA @ 15VDC;
Storage Temperature: -10ºC a 60ºC;
Operating Temperature: 10ºC a 50ºC;
Maximum humidity: 80% non-condensing;
Output Specifications:
Rated current: 0.5A;
Type: Open-Collector.
Inputs Specifications:
Rated Voltage at the Inputs: 3,3VDC low voltage;
Maximum permissible resistance of the contacts connected to
the inputs: 50Ω.
Wireless standard: Wi-Fi 2.4GHz
Physical Specifications:
Dimensions: 105mm X 90mm X 70mm DIN rail mounting (6 modules);
Protection degree: IP20, for indoor use. Self-extinguishing plastic box UL-94
V0.
ATTENTION:
Mordomus shall not be liable for any damages resulting from the
use of our equipment outside the specifications and/or for a purpose
other than that intended.
Never remove the circuit board from its housing.
Do not exceed the output ratings.
The module is not provided with additional protection against short
circuit, therefore it is recommended to use a power supply with the
correct specifications.
Do not connect power supplies with an output current greater than
4A.
Do not connect any voltage sources to the inputs of the iWL68.
Only connect potential free contacts to the inputs of the iWL68.
Overview:
DIP-Switch for configuration
Input connector
Output connector
Power supply connector 15VDC 2,1x5,5mm
Power supply
1. Installation
Perform all connections according to figure 1.
2. Connection to WI-FI network and enrollment to Mordomus
Method 1 - Automatic Setup (Router must support WPS)
1. Since factory, on powering up the iWL68 is in WPS negotiation mode
signaled by the connection status indicator blinking continuously in blue color.
Take care not to power up more than one Mordomus IoT device at the
same time since WPS allows for configuration of only one device at a
time. We recommend powering up and registering the devices in a sequential
manner.
2. Press the WPS button on the router according to the user manual of this
device and wait until the WPS negotiation is completed. This is signaled by the
connection status indicator blinking in red color and later blinking in green color.
v.2310 1/7