Publicidad
Idiomas disponibles
Idiomas disponibles
EN
CHARGING PROCEDURE (LED
INDICATOR)
BATTERY IS CHARGING
FULLY CHARGED
BATTERY IS TOO WARM (RE-
MOVE FOR APPROX. 30 MINUTES
TO ALLOW TO COOL)
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW BAT-
TERY)
Incorrect Defect Note:
1. Put the battery pack into the charger.
•
If the status LED blinks RED, remove the battery
pack from the charger for 1 minute.
2. Put the battery pack into the charger again.
•
If the status LED blinks GREEN, the battery pack is
good.
•
If the status LED stays blinking RED, remove the
battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
•
If the status LED shows blinks GREEN, the battery
pack is good.
•
If the status LED stays blinking RED, the battery
pack is defective and it is necessary to replace the
battery pack.
7.2
CHARGING TIP
See Figure 3.
When charging 3 batteries or less, place them on one side for
fastest charging.
7.3
EXAMINE THE CHARGER
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6° C to 40° C (42.8° F to 104°
F) .
If you attempt to charge the battery pack in a warm or hot
environment, and the charger LED light is red, remove the
battery pack and let the battery cool for approximately 30
minutes.
GREEN
BLINKING
GREEN
RED
RED
BLINKING
WARNING
English
8
MAINTENANCE
8.1
CLEAN THE MACHINE
Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or submerge in water.
•
Clear the unwanted material out of the air vent with a
vacuum.
•
Clean housing and the plastic components with a soft, dry
cloth.
Do not use strong solvents or detergents on the plastic
housing or components.
9
TRANSPORTATION AND
STORAGE
9.1
MOVE THE MACHINE
See Figure 4-5.
•
Move forward by the handle (1), or lift up the charger by
two handle grips (11).
9.2
STORE THE MACHINE
See Figure 6.
Remove the battery pack before you store the charger or
disconnect the charger.
You can store the wheel charger horizontallly or vertically.
10
TROUBLESHOOTING
PROBLEM
Charger doesn't
work. Charger
shows defective
mode. (LED
flashes Red)
6
NOTE
IMPORTANT
WARNING
POSSIBLE
SOLUTION
CAUSE
Try to remove and
reinsert the battery
pack in the charg-
er.
Battery pack or
Try charging a dif-
charger is defective
ferent battery
or there is a bad
pack.
connection be-
tween the battery
Unplug the charg-
pack and charger.
er and wait until
the red LED goes
out, then reconnect
the plug to the
power supply.
Publicidad
