Lionelo Mari Tour Manual De Usuario página 17

3.
Lift the canopy of the carrycot and put the mattress in it.
4.
Place the carrycot on the frame of the stroller (fig. 22), correct installation
will signal a characteristic audible "click".
5.
Connect the locking device, located under the bottom of the carrycot with
the frame of the stroller to improve the stability of the carrycot (fig. 23).
Make sure the carrycot is properly installed and cannot be freely removed from
the stroller frame.
Caution. The carrycot should be installed facing the person driving the stroller
so that the caretaker has eye contact with the child.
B.
Folding down the carrycot canopy
To fold the carrycot canopy, press both adjustment buttons at the same time,
then push the canopy down in the direction (fig. 24).
C.
Carrycot removal
The baby can be carried in the carrycot.
To remove the carrycot, first release its locking mechanism from the frame of the
stroller (fig. 23), then press the two support release buttons in sequence until you
hear a "click" (you do not need to keep these buttons pressed) and lift it (fig. 25).
Push the buttons on the carrycot supports and align them parallel to the ground
so that they do not interfere with putting the carrycot down (fig. 26).
Baby seat installation and removal (applies to 3-in-1 set)
•
The connectors are compatible with these products: Lionelo (Astrid, Mari
Carrier, Greet Carrier). Insert the adapters into the appropriate places on the
stroller frame until you hear a click on both sides and the adapters are locked.
•
The seat in the stroller frame should be installed so that the child in it is
positioned facing the person driving the stroller.
•
Place the baby seat on the frame of the stroller using the adapters (fig. 26).
You will hear a distinctive click. Make sure the seat is properly installed on
the frame of the stroller.
•
To unbuckle the seat as needed, remove the seat from the adapters.
•
To remove the adapter, press the bottom button on it (A, fig. 26) and remove.
‑ 17 ‑ EN