Bestron DSA220 Manual Del Usuario página 16

OPERATION - General
Your trimmer is intended only for domestic use. The trimmer head should be used for trimming and styling
the hair and facial hair. The small telescopic trimmer is for 'fine tuning' and for difficult to reach places. The
shaving head attachment is for trimming beards and moustaches.
1. Casing
2. Trimmer head
3. Shaver head
4. Telescopic trimmer
5. On/Off switch
6. Re-charging indicator light
7. Re-charging stand
8. Mains adapter
9. Cleaning brush
10. Attachable comb
11. Comb
12. Oil
OPERATION - Before use for the first time
1. Make sure the on/off switch (5) is in the 0 (off) position.
2. Insert the adapter plug (8) into the socket on the rear of the re-charging stand (7) (see figure 2).
3. Place the casing (1) in the re-charging stand.
4. Insert the adapter connector plug into the mains socket.
The re-charging indicator light (6) should come on. (red
light)
5. Leave the device to charge for at least 12 hours. The
device may become slightly warm during this time. This is
normal and does not indicate a fault. (green light)
6. Remove the adapter plug from the mains socket.
7. Remove the connector plug from the re-charging stand.
8. Remove the device from the re-charging stand. It is now
ready for use.
OPERATION - Trimmer
1. Make sure the on/off switch (5) is in the 0 (off) position.
2. Place the lip on the bottom of the trimmer head (2) in the oblique opening on the
casing (1). See figure 3. Press the top of the head forward to click the head into
place.
To remove the head, hold the top of the head and pull it backwards. Do so only
when the device is switched off.
3. Slide the attachable comb (10) over the trimmer, with the teeth to the front of the
trimmer head. See figure 4. Press on the back of the comb to click into place.
To remove the comb, hold by the lip on the bottom and pull it up. Do so only when
the device is switched off.
4. The comb has 5 possible settings allowing cutting depths of 2 mm, 4 mm, 6 mm,
8 mm or 10 mm. Set the comb by holding in the button on the top and moving the
top part of the comb backwards or forwards as required with the other hand.
To familiarise yourself with the different settings, we suggest you start with the 10 mm
setting. The trimmer can also be used without the attachable comb; it will then
remove more hair.
16
Instruction manual
Figure 1
Figure 2
Figure 3
Figure 4