Beper 50.960 Manual De Instrucciones página 12

Cyclone Vacuum Cleaner Use instructions
Parts description
1.Vacuum hose
2.Dust canister open button
3.Dust canister with handle
4.Dust canister removal button
5.Carry handle
6.Stowage for floor attachment
7.On/Off switch
8.Locking buttons for vacuum hose
9.Locking button for telescopic vacuum pipe
10.Telescopic vacuum pipe
11.Foot-operated mains cable recoil button
12.Upholstery attachment
13.Linking pipe
14.Floor attachment (brush head)
15.Adjustment lever for smooth or carpeted floors
16.Side vent
17.Upholstery attachment stowage
18.Linking pipe stowage
19.Mains plug and mains lead
20.Fine dust filter and bracket for the motor protection filter
21.Motor protection filter
22.Exhaust vent
23.Exhaust filter
Instructions for use
Before using the appliance, pull the cord to sufficient length and insert the plug to the power socket.
A yellow mark on the power cable shows ideal cable length. Do not extend the cable beyond the
red mark.
Using the appliance
Assembling the vacuum cleaner
1.Insert vacuum hose (1) (see fig. 1).
2.Connect telescopic vacuum pipe (10) to vacuum hose (1). Set telescopic vacuum pipe to desired
length with the aid of the locking button (9) (see fig. 3).
3.Fix desired attachment (12), (13) or (14) to the telescopic vacuum pipe (see fig. 2).
TIP: You can also fix the attachments directly to the end of the vacuum hose (1).
4.Pull out the mains lead (19) – no further than the yellow mark. If the red mark is visible there is no
more cable on the drum; pulling further may damage the drum (see fig. 4).
5.Insert the mains plug into a correctly installed mains socket (230 V~/50 Hz).
12