Publicidad
Idiomas disponibles
Idiomas disponibles
2. Determine if canopy is being used for bed.
If canopy IS being used: Stop here and revert to separate assembly instructions
packaged with Canopy. (Separate Box)
If canopy is NOT being used: Continue to Step 3.
3. Attach side rails to headboard and footboard by inserting hooked ends into the
corresponding slots. Apply downward pressure and ensure connections are secure.
4. Determine the correct center rail height by reviewing the selected side rail heights
(Step 1). For lower position (boxspring level) attach the (3) shorter support legs to
the center rail. Insert the ¼" x 2" Allen bolts through the pre-drilled holes on the
top side of center rail and into the shorter legs. Tighten with Allen key (E). For
higher position (platform level) attach the (3) longer legs. The unused set of legs
can be attached to the bottom side of the center rail for storage. Align them
horizontally and attach with the single ¼" x 4½" Allen bolt (C).
5. Attach
center
corresponding pre-drilled holes. Insert the ¼"x ½ " Allen bolts (A) and tighten with
Allen key (E). Levelers on bottom of support legs can be adjusted for uneven floors
by turning until contact is made with floor.
Step 4.Detemine center rails height Step 5.Attach center rails to HB & FB
rail
to
headboard
Step 3.Attach side rails
and
footboard
by
Page 2 of 3
aligning
end
plates
Adjust leveler
if needed
with
Publicidad
