Publicidad
Idiomas disponibles
Idiomas disponibles
product. Contact the distributor via the
service address given in the warranty
section.
Before using the product for the first time,
„
please fully charge the battery (see section
'Charging the battery').
z Operation
The product can be operated in different
modes. The operating mode is selected by
pressing the On/Off button
(see Fig. A).
Press the On/Off button
„ „
switch between modes:
Press 1 x – 100% (battery life: 1.5 hrs)
Press 2 x – 50% (battery life: 3 hrs)
Press 3 x – Flashing light
Press 4 x – Off
z Hanging up your LED
camping light
You can hang this product in any suitable
„ „
place by means of the hook
lift the carry handle
integrated hook
2
RISK OF DAMAGE!
Never hang the product above an
open fire or heat source, as this may
damage the product and lead to injuries.
You can easily carry the product around
„ „
using the carry handle
D).
z Charging the battery
There are two different ways to charge your
LED camping light.
The charge status indicator
indicates the charge status of the
rechargeable batteries: 30% – 60% –
100%. The first LED will start flashing when
the battery charge is low.
PLEASE NOTE! The product cannot be
42
GB/IE/NI/CY/MT
repeatedly
4
as follows to
4
. To do so,
2
and then fold the
1
upwards (see Fig. D).
(see Figs. A and
1
(see Fig. A)
3
switched on during the charge process. It is,
therefore, not suitable for continuous
operation.
Charging the battery with the charging
cable
RISK OF ELECTRIC SHOCK!
Only charge the product in dry,
interior rooms, as the splash water
protection (IP44) cannot be guaranteed
when the micro USB charging cable is
connected.
Open the USB cover
„ „
micro USB charging jack
and connect the micro USB charging cable
contained in your package with the
5
charging jack
of your LED camping
7
light.
To charge the battery, connect the micro
„ „
USB charging cable
adaptor (SELV – 5 V, max. 1 A, not
included).
Plug the USB mains adaptor into a power
„ „
outlet.
All LEDs will start flashing and the battery
„ „
will start charging. The more LEDs light up
continuously, the higher the charge status of
the battery.
Charging takes approximately 3 hours.
„ „
When the LED camping light is fully
„ „
charged, all of the LEDs in the charge status
indicator
will remain constantly on.
3
You can now unplug the USB mains
„ „
adaptor from the socket and the USB
charging cable from the product.
Place the USB cover
„ „
to protect the product from humidity and
ensure splash water protection.
Charging the battery with the dynamo
Turn the product off (see section 'Operation')
so you do not slow down the charging cycle
of the product.
that covers the
6
(see Fig. B)
7
to a USB mains
5
over the jack again
6
Publicidad
