Publicidad
Idiomas disponibles
Idiomas disponibles
Insatallation
Step 1:
Remove the head unit from your dashboard.
Important: Depending on how your head unit was installed you may have to remove part or
all of your dash board before the head unit can be pulled out. You may also have to remove
screws to complete this step.
Note: Before proceeding, make sure that the PIA has been programmed. Refer to the
PIA Installation Manual. Professional installation is recommended.
Step 2:
Connect the 34-pin cable connector to the Programmable Interface Adapter (PIA) mating
connector as shown in Fig. 1. Slide the rubber strain relief onto the PIA case. Attach the Car
Dock USB connector into the USB receptacle on the PIA. Make sure the connectors are
secure, and slide the top cover onto the bottom housing. (Refer to Fig. .)
Yellow and
black wire are
optional, based
on model.
Mini-Tuner and
Car Dock
Connector
Yellow Wire,
atter
Fuse
Ground Wire
Fig. 1 PIA Cable Interface
Antenna
Mating
Connector
Note: Make sure all cables
are securely connected
Publicidad
