Bestway 43645 Manual Del Usuario página 9

Read the manual and follow the instructions relating to safety tips, correct and complete product assembly,
setting into service, use and maintenance.
For your own safety, always heed the advice and warnings in these instructions.
Non-compliance with these operating instructions may expose you to serious danger.
Only use the product in the places and conditions for which it is intended.
• ATTENTION! NO PROTECTION AGAINST DROWNING!
• SWIMMERS ONLY!
• Full inflate all air chambers.
• Passenger numbers and load weight shall by no means exceed passenger number and maximum weight
capacity in specifications.
• This product should not be used as life saving device.
• Life saving device (life jacket and life buoy) must be prepared together and inspected.
• Keep away from flames and fires.
• Before every use, carefully inspect all product components, to ensure everything is in good condition and
tightly secured. Please stop to repair if you find any damage.
• Be careful when landing on the ground. Sharp and rough objects such as rocks, cement, shells, glass, etc.
may punctured the product.
• Don't leave the product exposed to sun for long periods of time, as high temperatures shall give rise to air
expansion, which can cause irreparable damage.
• Never leave in or near the water when not in use.
• Evenly distribute loads when use the product. Tipping and drowning may occur with uneven distribution of loads.
SAVE THESE INSTRUCTIONS
ASSEMBLY
WARNING: Adult assembly required.
Take the island and accessories out with care. Spread the island out.
WARNING: Poles contain fiber glass. We strongly recommend wearing gloves during assembly to avoid
irritating hands.
INFLATION
1. Before using the product, carefully check if there are any leaks or broken parts. Open safety valve and inflate
with the air pump (not include) to design working pressure on the product.
2. Fill the chambers until most of the wrinkles are gone and it feels firm to touch but NOT hard. If you use other
pressure gauge, the pressure should not be more than the specified pressure on the product or on the
instruction. Do not over-inflate the product. Do not use an air compressor.
NOTE: Under and over-inflation of the product will result in safety hazards. It is better to check the pressure
of the product each time before using.
3. Be sure to close the valves after inflation, press in the safety valves after inflation.
NOTE: Never stand on or rest objects on the product during inflation. Always check product for leaks before
use.
DEFLATION AND DISMANTLING
1. Dismantle the sunshade from the island.
2. Open and pinch the bottom of the valves to deflate.
MAINTENANCE AND STORING
1. After deflation, use a damp cloth to gently clean all surfaces.
NOTE: Never use solvents or other chemicals that may damage the product.
2. Store in a cool, dry place, out of reach from children.
3. Check the product for damage at the beginning of each season and at regular intervals when in use.
REPAIR
If the product is damaged, use the provided repair patch.
1. Clean the area to be repaired.
2. Carefully peel the patch and remove it from the backing.
3. Press patch over the area to be repaired.
4. Wait 30 minutes before inflation.
303021292120_43645_10x14cm_带遮阳篷4人浮岛说明_英
WARNING
9