RIDGID SeeSnake microREEL APX Manual Del Operador página 11

Operating Instructions
Placement
Set up your microREEL near the pipe en-
trance so you can manipulate the push
cable while viewing the display. Use the
kickstand to position the microREEL so that
it does not tip during use.
Opening the microREEL Case
Make sure the camera is completely in-
side the drum before unlatching and
opening the microREEL case. Do not
open the microREEL case while the
camera is stored in the camera clip. If the
camera is not in the drum, the push cable
can unwind and cause damage or seri-
ous injury.
Open the microREEL case to route the
camera, replace the drum, rewind the push
cable, and to maintain and clean the system.
1. Set the unit on a level surface and lay
it on its back.
2. Unfasten the case latches on either
side of the microREEL.
3. Carefully open the front case and lo-
cate the camera head in the push
cable drum.
4. Route the camera head out through
the push cable guide in the front of the
case.
5. Secure the camera head in the clip.
6. Close and relatch the case.
microREEL APX / microREEL CA – English – 11
WARNING
Case Latch