Preparation of coffee/tea/drinks
Use only capsules that are specific for this model.
•Place a cup under the dispenser
•Slowly lift the control lever (1) back (until it stops)(Fig. 9)
and introduce a capsule in the slot provided (Fig. 10).
IMPORTANT:
Before inserting the capsule, slowly lift the control lever (1) located on
the top of the machine.
For correct hygiene it is advisable to reject the capsule immediately
after dispensing: to do this, completely open the lever (1) as far as
it will go
Fully lower the lever and press button (3) until the desired quantity has been released, then press
button (3) again to stop (Fig. 11).
•Repeat the steps above for additional cups of coffee/tea using a new capsule for each drink.
To prepare a large coffee, prepare an Espresso first, then press button (3) until the desired quantity
of hot water is dispensed.
•To extract the capsule slowly open the lever (1) and push it as far as it will go.
If the capsule does not come out, repeat the procedure or press the start button (3) while simultaneously
lifting the lever (1).
NOTE
The machine is equipped with a pre-brewing system: when a dispensing button (3) is pressed it
starts dispensing, stops for a moment and restarts automatically.
HINT:
•To prepare a good espresso use thick cups, possibly preheated, so that the coffee will not cool
too quickly. The cups can be heated by rinsing them under the hot water dispenser.
•Preheating the cups using the water in the machine is useful when starting dispensing
to bring it to steady dispensing temperature.
Fig. 9
1
Fig. 10
20
reject
3
Fig. 11
open
1