ProBreeze PB-15 Manual De Instrucciones página 12

Lights
• Auto, filter, continuous lights: these will illuminate when the modes are activated.
• Defrost: this will illuminate when frost builds up on the evaporator coils. When this happens,
the compressor will turn off and the fan will continue to run until the coils defrost.
• Full: this will illuminate when the water tank is full and needs to be emptied. To empty, follow
the instructions listed below.
Display
• As a default, the LED display will show the RH (relative humidity) of the room to +/- 5%
accuracy.
• If there is a problem with the unit, the following will display:
• P2: water tank is full or not in the right position. Empty the water tank or check its
positioning.
AP: device is in auto-pairing mode, which is used to connect to wifi. This mode should
•
turn off automatically within 8 minutes.
• AS: humidity sensor error. Unplug the unit, wait 30 seconds and plug back in. If the
problem persists, contact support.
ES: tube temperature sensor error. Unplug the unit, wait 30 seconds and plug back in. If
•
the problem persists, contact support.
CONNECTING TO WIFI
― ―
NOTE: if you are having issues connecting to Wifi, please ensure your network is set to 2.4G. If
you are continuing to have issues, please contact our customer care team by emailing help@
probreeze.com
• To connect to Wifi, hold the filter button down for 3 seconds, or until the LED display shows
"AP" (auto-pairing). When in auto-pairing, the compressor will be forced off.
• Download the "NetHome plus" app, select "add device" and then select "dehumidifier".
Follow the instructions. All instructions can also be found in the App User Manual included
with this unit.
• If the connection is successful within 8 minutes of entering AP mode, the device will resume.
• If the connection is unsuccessful after 8 minutes of entering AP mode, the device will
resume.
• Once connected, you can view performance and control your dehumidifier through the app.
EMPTYING THE WATER TANK
― ―
CAUTION: ALWAYS TURN THE UNIT OFF AND REMOVE THE PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE WATER TANK.
• Do not transport the unit with water in the water tank. This may cause the unit to tip over or
the water to spill.
• Be careful when removing the water tank from the unit to avoid spilling water.
12 of 124 | English