AREA ZERO+ CSI - R129 omologato lingue ok_Layout 1 11/03/19 16:29 Pagina 26
CAR SEAT 40-75 cm
FOR CHILDREN Up TO 75 cm
Child's height 40 cm. - 75 cm.
Maximum weight of the child 13 kg.
If the car manual does not state that it is
compatible with the "i-Size" system, the
base and the car seat can be fitted on
seats compatible with the IsoFix system
(as specified in the vehicle manual).
Contact the car manufacturer or consult
the dealer for further information.
7. HOW TO FIT THE ISIZE BASE
Position the seat protectors where the
Isofix anchoring points are located. The
protectors make fitting easier and
protect the seats.
8. Insert the metal tube in the holes in
the rear part of the shell.
Check that the securing springs have
fastened correctly.
9. Turn the support leg forwards to open
it out completely.
10. Lift the handle located in the central
part of the base to pull out the IsoFix
connectors fully.
11. Make sure that the indicators on the
IsoFix connectors are red. If this is not the
case, operate the connector releasing
system shown in the figure until the
indicators change colour.
12. Position the base on the seat of the
vehicle.
Insert the connectors in the two
protectors.
13. Push the base backwards so that the
two IsoFix connectors click onto the
anchorage points in the car. Two clicks
must be clearly heard.
Lift the handle located in the central part
of the base and, at the same time, move
the base slightly towards the seat.
14. Push the base backwards until it rests
fully against the backrest of the vehicle
seat.
24
Caution: check that the base is securely
in place once again by trying to pull it and
move it.
15. HOW TO ADJUST THE SUppORT
LEG
Press the button and adjust the length of
the leg until it touches the floor of the
car.
To adjust the length correctly, make sure
that the foot touches the floor of the car
and that the car seat rests on the seat of
the vehicle.
Make sure that the indicator is green.
Check that the leg is fixed securely, in
other words that the length cannot be
hanged unless the button is pressed.
16. HOW TO REMOVE THE BASE
Pull the connector release system
forwards to release the Isofix connectors.
When the connectors are no longer
connected, the indicators on the isoFix
connectors turn red.
Move the base away from the seat.
17. It is advisable to return the support
leg to its shortest position by pressing
the button and pushing the leg upwards.
Turn the support leg under the base to
reduce its overall size to a minimum.
Lift the handle located in the central part
of the base and, at the same time, push
the IsoFix connectors inside the base to
reduce its overall size to a minimum.
18. HOW TO FIT THE CAR SEAT TO
THE ISIZE BASE
Fasten the car seat to the base. Make
sure that the indicators located on the
front part of the base show green.
Caution: make sure that the car seat is
fitted securely by trying to lift and move
it.
19. Position the carry handle in the
position shown in the figure.