3TECH LED-1007 Manual De Usuario página 3

en
WIRELESS LED LIGHT CURING UNIT
Introduction
Thank you for choosing Curing Light LED-1007. For safety reasons and to achieve the
best results, please read the user's guide carefully before using the product.
This user guide describes the normal properties of the Curing Light LED-1007, and
introduces the principles of the safety issues, installation, usage and maintenance.
We are always trying to improve our products, this may result in small changes of the
components.
Before the fi rst use, please check the accessories and make sure they are all in good
condition.
1. Main unit, 2. Light guide, 3. Battery, 4. Charge, 5. Adapter, 6. Light cover plate,
7. User manual
Structure
Power Display
button screen
Light guide rod
Spécifi cations
Size ................................................... dia 22 x 175mm (LED Light)
Weight ........................................... 165 gr
Safety class ................................ Ordinary type B, non-continuous service, IP 40, Class II
Input voltage ............................ 100-240 V, 50-60 HZ
Battery capacity ...................... 2200mAH
Wavelength ................................ 430-485nm
Intensity ........................................ 5W>1100 mW/cm²
Polymerisation ......................... 10s, > 3mm (5W)
Usage
Battery charge
Connect the adapter to the AC power and connect then adaptor to
charger. Place the handpiece on the charger. When charging, the
charging indicator (yellow) is on and the power indicator (green) is
o . When the battery is fully charged, the charging indicator (yellow)
is o and the power indicator (green) is on.
Yellow Green
When using a new battery for the fi rst time, it is best to charge it
for 6-7 hours, but it should not be charged for over
7 hours. When battery is full charged, please disconnect
the AC power.
4
Mode Time
button button Battery
Operation
A) Power on/o : When the unit is o or standby,
press power button to start the unit working, the
light output shows a blue light, press the button
again to stop working and turn to standby.
B) Mode select: Press mode button to select three
types of work mode:
01 Gradual/Ramping mode
02 Flashing mode
03 Full light mode
C) Time select: Press Time button to select time.
Four time settings: 10/20/30/40 seconds can be
chosen.
D) When the unit is working, the buzzer will beep
every 5 seconds.
E) Automatically power down: When he unit is in
standby without the button being pressed for 8
minutes it will turn o automatically.
F) Low battery alert: If when starting work the unit
power and the voltage of the battery is lower than
the required level the unit will give an alarm; the
buzzer beeps 5 times and the indicator fl ashes the
stage. Please charge the battery in time.
Notice
1. The working time between each handling is not less than 30 seconds.
2. Please replace the light guide when it has cracked or show scratches.
3. Disinfection of the light guide: immerse the rod in 75% alcohol several minutes.
4. When the battery is fully charged, please disconnect the AC power.
5. Avoid touching the electrodes of the battery with metal.
6. Please use a swab with anhydrous alcohol to clean the pins in the charger regularly,
this should avoid weak contact from charger to handpiece.
5