Symbols; Safety Symbols - skilsaw SPTH15 Instrucciones De Funcionamiento Y Seguridad

Batería de iones de litio
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety Symbols

The purpose of safety symbols is to attract your attention to possible dangers. The safety
symbols and the explanations with them deserve your careful attention and understanding. The
symbol warnings do not, by themselves, eliminate any danger. The instructions and warnings
they give are no substitutes for proper accident prevention measures.
WARNING
"WARNING," and "CAUTION" before using this tool. Failure to following all instructions listed
below may result in electric shock, fire, and/or serious personal injury.
The definitions below describe the level of severity for each signal word. Please read the manual
DANGER
WARNING
CAUTION
Damage Prevention and Information Messages
These inform the user of important information and/or instructions that could lead to equipment
or other property damage if they are not followed. Each message is preceded by the word
"NOTICE", as in the example below:
NOTICE: Equipment and/or property damage may result if these instructions are not followed.
4
Be sure to read and understand all safety instructions in this Owner's
Manual, including all safety alert symbols such as "DANGER,"
and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to potential personal
injury hazards. Obey all safety messages that follow this symbol to avoid
possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous
situation which, if not avoided, will result in minor or moderate injury.
WARNING
in severe eye damage. Before beginning power tool operation, always
wear safety goggles or safety glasses with side shields and a full face
shield when needed. We recommend a Wide Vision Safety Mask for use
over eyeglasses or standard safety glasses with side shields. Always use
eye protection which is marked to comply with ANSI Z87.1.

Symbols

The operation of any power tools can result in foreign
objects being thrown into your eyes, which can result

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido