Jackery Explorer 3000 Pro Manual Del Usuario página 6

AC Output Reset Button: When the Reset Button pops up, you need to remove the load and press the
Reset Button to reset.
AC Input Reset Button: When the Reset Button pops up, you need to remove AC charge cable and
press the Reset Button to reset.
EPS: Emergency Power System. Once you have connected the mains and the AC input port of the EPS
via the AC charger cable, you can use the AC output port of the EPS to power your unit (at this point
the AC power comes from the mains, not the EPS battery). In the event of a sudden loss of mains
power, the EPS can automatically switch to battery mode within 20ms. Since this is a non-profession-
al UPS function, it does not support 0ms switching. Do not connect to equipment with high
uninterruptible power requirements such as data servers and workstations. Please test several times
to confirm compatibility before use and it is recommended to connect to only one device. Do not use
more than one unit at a time to avoid triggering the overload protection. Failure to follow these
instructions may result in equipment failure or loss of data for which we cannot be held responsible.
APP CONNECTION
This product supports the connection of Jackery App for intelligent control and operation. Users can
download the Jackery App through App Store or Android application markets. Please refer to the User
Manual for Jackery App for detailed connection instructions.
CHARGING YOUR JACKERY EXPLORER 3000 PRO
Green energy first: We advocate to use the green energy first. This product supports two modes of
charging at the same time: solar charging and AC wall charging.
When AC wall charging and solar charging are turned on at the same time, the product will give
priority to solar charging and both methods will be used to charge the battery at the maximum
permissible power.
CHARGING FROM THE WALL
Please use the AC cable included in the package.
SOLAR ENERGY CHARGING
Jackery SolarSaga 200 or 100 or 60 Solar Panel Connection Guide
If one or two solar panels are connected, you can directly connect the DC8020 port of the solar panel
to theDC8020 port of Jackery Explorer 3000 Pro for charging. If three or four solar panels are connect-
ed, please refer to the method shown in the following figure to charge through the solar series connec-
tor (Note: The solar series connector is not in standard configuration, so you need to purchase it separately.
Please refer to the detailed operation instructions of the solar series connector before using it.)
SolarSaga ×3
05
Explorer 3000 Pro
AC Charger
Explorer 3000 Pro