Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
6. Driving Brad Nails
WARNING: Never wedge or hold back the
workpiece contact mechanism during operation of
the tool. Doing so could result in possible serious
injury.
NOTICE: If no other action is taken after the
power switch (A) is pressed, the nailer will turn off
automatically after 30 minutes.
Single Sequential Actuation Mode:
Single sequential actuation provides the most
accurate nail placement.
a. Make sure the workpiece is secured before
performing any operation.
b. Attach the battery pack and start the tool by pressing the power switch (A).
c.
Briefly press the mode select button (B) to select the single sequential actuation mode " ".
d. Grip the tool firmly to maintain control. Position the nose of the tool onto the work surface.
e. Push the tool against the work surface to depress the workpiece contact (G). Then
squeeze the trigger switch (J) to drive a nail.
f.
Release the trigger switch (J) and lift the nose from the workpiece to complete the nailing action.
g. Repeat the steps 'd' through 'f' to drive more nails.
NOTE:
• Hold the trigger squeezed until drive cycle is complete.
• If there is no more action for more than 10s after workpiece contact (G) pressed without
releasing, firing will be locked unless users release both workpiece contact (G) & trigger
switch (J) and try again.
Contact Actuation Mode:
Contact actuation allows very fast repetitive nail placement.
a. Make sure the workpiece is secured before performing any operation.
b. Attach the battery pack and start the tool by pressing the power switch (A).
c.
Briefly press the mode select button (B) to select the contact actuation mode " ".
d. Grip the tool firmly to maintain control.
e. Squeeze and hold the trigger switch (J).
f.
Push the tool against the work surface to depress the workpiece contact (G) and drive a nail.
g. Keep the trigger squeezed, relocate the tool to the next nailing spot and push the tool
against workpiece to drive another nail.
h. Release the trigger (J) when done.
NOTE:
• Contact actuation mode still retains the logic of the single sequential actuation mode. This
means the tool can also be operated by depressing the workpiece contact (G) against the
surface and squeezing the trigger switch (J).
• If there is no more action for more than 10s after workpiece contact (G) or trigger switch (J)
pressed without releasing, firing will be locked unless users release both workpiece contact
(G) & trigger switch (J) and try again.
6
J
M
12
A
G
B
Publicidad
