Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
CAUTION: Before performing any work on the power sprayer, always switch off the motor and pull the spark plug connectors off the spark plug.
Always wear protective gloves!
CAUTION: Start the power sprayer only after having assembled it completely.
1. ASSEMBLY OF NOZZLE
Refer to the figure on the previous page (DESIGNATION OF PARTS) to assemble handgrip, nozzle lever, nozzle pipe and nozzle. Be careful to
put parts together properly to prevent leaks.
2. SETTING OF SHOULDER HARNESS
Set the two shoulder harnesses on a chemical tank in a way shown below without any twists of the shoulder harnesses. Instructions are given
about the ones for one of the shoulder harnesses.
Setting upper part of shoulder harness
①
Chemical tank
Upper buckle
Setting lower part of shoulder harness
Upper buckle
Lower buckle
②
①
Chemical tank
Put the back harnesses 'A'. one of the two
overlapped harnesses, at the metallic hook in
a way shown below at ② and ③ .
③
②
Put the part 'A', of the harness through
this gap of the metallic hook.
Then raise the harness to
the degree of 90, in the
direction of the arrow.
Metallic hook
Repeat the same instructions for the
③
other shoulder harness to finish the
setting.
Metallic hook
8
Pull the harness in the direction of
the arrow and put its folded end at
the lower end of the buckle.
Publicidad
