Steren EL-101 Manual Del Usuario

Before using your new Switch, please read the following
recommendations
• Make sure to disconnect the electrical current system, before make
any installation or re-installation.
• If you don't have any electricity knowledge, go with an electrician.
• Easy to install and cheap.
Product: Switch
Part number: EL-101, EL-102, EL-114
Brand: Steren
This Steren product is warranted under normal usage against defects in
workmanship and materials to the original purchaser for one year from the date
of purchase.
1.- This warranty card with all the required information, invoice or purchase
ticket, product box or package, and product, must be presented when
warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free of
charge.
3.- The repairing time will not exceed 30 natural days, from the day the claim
was received.
4.- Steren sell parts, components, consumables and accessories to customer, as
well as warranty service, at any of the addresses mentioned later.
THIS WARRANTY IS VOID IN THE NEXT CASES:
If the product has been damaged by an accident, acts of God, mishandling, leaky
batteries, failure to follow enclosed instructions, improper repair by unauthorized
personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty service in the purchase
establishment.
b) If you lose the warranty card, we can reissue it, if you show the invoice or
purchase ticket.
RETAILER INFORMATION
Name of the retailer
Address
Product
Brand
Part number
IMPORTANT
FEATURES
I
WARRANTY
CONDITIONS
INSTRUCTIONS
1.- Remove the plastic cover of the cable in one of the ends, about 5 or
6mm (1/2 cm), if you cut more than 6mm probably can't make contact
and have an electrical shock. Repeat the process on the other end.
Insert the ends on the holes located asides of the switch
2.- Slack the screws from the terminal, just the enough to insert the
ends of the cable (ends without plastic cover) (roll the end to avoid
loosen threads).
3.- Insert the ends of the cable on the terminal and fasten them, using a
screwdriver, tightly to make a good contact.
4.- In the model EL-114 to remove the lid, it is necessary to remove the
screws.
SPECIFICATIONS
Input
EL-101/102
125V~ 10A
EL-114
125V~ 3A
Product design and specifications subject to change without
previous notice.
Serial number
Date of delivery
In case your product fails or have any doubt, please contact your
nearest retailer. If you are in Mexico, please give a call to our Call Center.
Call Center
01 800 500 9000