Publicidad
Idiomas disponibles
Idiomas disponibles
4. Preserving the batteries: In order to maintain the optimum capacity of the
rechargeable batteries, the clipper should be recharged for 3 hours approximately
every 6 months.
5. Make sure the switch is in the OFF position when the clipper is not operating.
6. If the charging light starts to flash rapidly (more than 4 flashes per second) then the
appliance is faulty. If this happens then please stop charging and remove the adapter
from the mains and contact an authorized Service Center.
FOR DIRECT PLUG-IN OPERATION
Make sure clipper is off. Connect charging jack into the receptacle at the end of clipper
and plug the adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to ON (marked " "). To stop operation, set to the OFF
(marked " ") position.
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for
proper functioning. Failure to regularly clean and oil the blades will void the
warranty.
USER MAINTENANCE INSTRUCTIONS
MAINTENANCE OF THE BLADE
Always apply oil to the blades before and after use. This will ensure maximum cutting
performance and proper maintenance. Hold the clipper away from your body in a
downward position, and apply a drop of BabylissPro lubricating oil on the front and
sides of the cutter blade. Wipe off excess oil with a soft, dry cloth.
Do not pull, twist, or wrap the supply cord around the appliance.
FX870GBPUZ IB-22_123.indd 5-6
FX870GBPUZ IB-22_123.indd 5-6
HOW TO USE COMB ATTACHMENTS
To use the comb attachments, turn the clipper to " " position. Slide the
comb attachment onto the top of the clipper blade, and then pull down and
over the back of the blade. To remove, pull up on the back of the comb
attachment and then pull away from the blade.
REPLACEMENT (REMOVAL) OF BLADE SET
Step 1. Unplug the unit and adjust the taper (see
illustration A).
Step 2. Remove the screws and the fixed blade. Save
the screws.
Step 3. Lift off the small moving blade and replace it
with the new one on the plastic oscillator (see
illustration B).
Step 4. Replace the fixed blade using the screws and lightly tighten them. Adjust the
teeth as shown in illustration C, to a gap of 1/32" (1 mm) to 1/16" (1.5 mm),
and the small, moving blade as centered and parallel as possible to the fixed
blade's teeth.
IMPORTANT NOTE:
The top edge of the fixed blade must be a minimum of 1/32" (1 mm) higher than the top
edge of the moving blade, as centered as possible. This is important so that the moving
blade does not come in contact with the skin.
Be sure to add a few drops of BabylissPro lubricating oil to the blades before running.
Don't forget to tighten the screws after the blades have been aligned.
C.
Fixed Blade
Small
Moving
Blade
B.
A.
Plastic Oscillator
Taper
Small
Moving
Blade
1/32" to 1/16"
2022/5/6 3:21 PM
2022/5/6 3:21 PM
Publicidad
