American Standard Ovation Curve AM00846400 Manual Del Propietário página 7

2
INSTALLING FIXED PANELS
• In this step, you'll need following parts: [1] x1, [4] x2, [9] x1, [11] x1, [14] x4, [17] x1, [28] x1
• In this step, you'll need the following tool: B
NOTE: TWO PEOPLE REQUIRED
2c
[1]
2a
[9]
2e
NOTE: Fixed Panel A [9] MUST be installed on left side only. See above illustration for reference.
2a. Insert Fixed Panel A [9] into Wall Post [3].
2b. Ensure Fixed Paned A [9] fits fully into the Wall Post [3] as illustrated. Then install Fixed Panel B [11]
on the right (opposite) side in the same manner.
2c. Place Top Rail [1] from inside of shower area and align holes in Top Rail [1] with holes in Fixed Panel A [9]
on left side. Attach Top Rail [1] to Fixed Panel A [9] using 2 Fasteners [14] and screw into the Top Rail [1].
2d. Tighten the 2 Fasteners [14] turning clockwise using supplied 2mm Allen Key [17] placed into a hole in
Fastener. Ensure the clear plastic spacer of the Fastener [14] stays in the hole of the Fixed Panel. Do not
overtighten Fasteners [14] or damage to the glass Fixed Panels may occur. Repeat on the opposite side
for Fixed Panel B [11].
2e. Place Inserted Gaskets [4] from outside of shower area, between Wall Post [3] and Fixed Panel A [9]
using supplied Installation Aid [28] while checking level on top of panel.
2f. Fully press Inserted Gasket [4] into Wall Post [3] between Fixed Panel A [9] and Wall Post [3] as illustrated.
Repeat on opposite side. NOTE: Closely check the gasket and ensure it is fully inserted as the gasket aids
in securing the glass panel to the wall post and provides a water tight seal.
2a
[3]
2c
2c
=
2a
[11]
[14]
2e
2e
=
[3]
2b
[9]
[3]
2d
[1]
[9]
2f
[9]
[4]
[28]
[4]
[9]
[17]
[14]
[1]
[9]