Custom Cable - Beyerdynamic CUSTOM STUDIO Manual Del Usuario

Changing the Headband Pad
The special shape of the headband pad protects the fontanelle against too much
pressure. If necessary, please replace the headband pad as described in the
following.
1. Open the snap fasteners and remove the padding from the headband. Take
care not to damage the cable.
2. Place the new opened headband pad on the underside of the headband. Make
sure to lay the cable in the crease of the pad on the outer edge of the band.
Tip: to do this, splay the headphones slightly, over both knees, for example.
3. First close the middle snap fasteners and then the two outer ones.
Changing the Ear Pads
1. Place the lip of the ear pad in the notch at the top of the headphone casing.
2. Then turn the ear pad on the right-hand casing clockwise and the left-hand
casing anti-clockwise until the lip of the entire pad is sitting outside the
casing.
1.
Notch
2.
Notch

CUSTOM Cable

The cable couldn't be more flexible – and just like the headphones, can be
modified with ease. Various cable options and headsets can be found at:
www.beyerdynamic.com/custom
Changing the Cable
1. Pull the cable, which is connected at one side, out of the headphones.
2. When inserting the new cable, make sure that the slot in the connector
housing is turned towards the detent in the housing shell.
1.
Maintenance
For reasons of hygiene, the headband should be cleaned occasionally with a soft
damp cloth.
You may need to change the ear and headband pads from time to time as a
result of normal wear and tear. This is easy to do yourself. In the event that other
components need to be replaced, please contact your local beyerdynamic
representative.
2.
8 | 9