North State 4955 Manual De Instrucciones página 3

Step 3
Set the appropriate width of the gate by
overlapping the two frames to the extent
necessary to allow room for the spindles on
either side of the gate. The minimum allowable
overlap is two bars. The maximum allowable
overlap is seven bars.
Note: The spindles are adjustable to
accommodate the gap between the gate frame
and the opening.
The assembly fi�ngs MUST be installed onto
Step 4
the gate frames to keep the gate secure. Secure
the gate frames together by installing the upper
and lower assembly fi�ngs onto the gate frame.
Step 5
Note: *Do not mount hardware into sheetrock or plaster.
Hardware is included for use in solid materials only such as
wood or metal.*
Hold template (A) against the surface to which the gate is to
be fi�ed (hinge side). Ensure the template is ver�cal,
completely outstretched and that the end marked "
the floor. Mark the screw hole posi�ons.
Step 6
Disconnect both the upper and lower hinges by sliding the
top hinge pin/hinge apart. Secure the lower and upper
hinges with the moun�ng screws with the post poin�ng
upwards as shown.
Note: Do not secure the top hinge with pin at this �me.
Step 7
Hold template (B) against the surface to which the gate is to
be fi�ed (latch side). Follow the direc�ons in step 5.
" is on
Page 3
Hinge
Handle
latch side