Publicidad
Idiomas disponibles
Idiomas disponibles
Technical Data
Code
Description
Bit holder
Voltage
Speed
Rotation
Torque
IP Gradre
Battery
Charger
MAX-20D
WARNING
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING
Power Requirements
WARNING
Tools with double insulation are equipped with a polarized plug
(one prong is wider than the other). This plug will only fit in the right way into a
polarized outlet. If the plug cannot be introduced into the outlet, reverse the plug. If
it still doesn't fit, call a qualified electrician to install for you a polarized outlet. Do
not alter the plug in any way. Double insulation eliminates the need of both a
grounded third power cord with three prongs or a grounded power connection.
WARNING
When using an extension cable, verify the gauge is enough for
the power that your product needs. A lower gauge cable will cause voltage drop in the line, resulting in power loss and
overheating. The following table shows the right size to use depending on cable's length and the ampere capability shown in
the tool's nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
WARNING
When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are especially designed
for operating outdoors and reduce the risk of electric shock.
Cordless Impact Screwdriver (with accesories) / Cordless Impact Screwdriver
0 - 1 800 RPM
0 - 2 100 RPM
0 - 2 700 RPM
Ion-Lithium 20 V
Input:
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
Before gaining access to the terminals all power sources should be disconnected.
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE
MAX-20D
MAX-20DS
101402
1/4"
20 V
Blows per
minute
Forward - Reverse
73 lb-ft
100 Nm
95 lb-ft
130 Nm
184 lb-ft
250 Nm
IP20
2 Ah | Charging time: 1 hour approximately.
Voltage:
127 V
Frequency: 60 Hz
Current:
1.1 A
Power Cord Grips used in this product: Type "Y".
Tool Build Quality: Class III
Charger tool build quality: Reinforced insulation
Extension gauge
from 6 ft to 49 ft
18 AWG( * )
16 AWG
14 AWG
8 AWG
grounded
101406
0 - 1 400 BPM
0 - 2 250 BPM
0 - 3 780 BPM
Output:
21.5 V
3.5 A
Authorized Service Center.
|
higher than 49 ft
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3
Publicidad
