Windgoo T8 Manual Del Usuario página 7

Accelerator start
Cruise control
Brake
Automatic
shutdown
4. Charging
(1) Complete scooter charging
The charging port is located at the bottom of the battery. You can open the waterproof glue
plug of the charging port, insert the designated charger, connect the power supply, and
then after the charger indicator light shows red, start the charging. When the indicator light
of the charger turns green, it means that the battery is fully charged, and then you can
unplug the charger and close the waterproof glue plug of the charging port.
(2) Battery charging
As the battery of this model is of detachable type, it can be charged independently after
being taken out of the body. You can open the waterproof glue plug of the charging port,
insert the designated charger, connect the power supply, and then start the charging.
(3) Charging safety indications
① The battery should be charged for at least 5 hours before the first operation.
② In order to maximize the battery life, the battery should be charged once every other
month or every 2 days after riding. Please charge the battery at a suitable temperature,
without charging under high temperature/sun exposure.
③ Please use the battery, charger and cable provided by the original manufacturer to
avoid the danger of overcharge.
④ Make sure that the charger cable is connected properly and the environment is well
ventilated.
⑤ Make sure that it is used in a dry environment, and prevent the charger or cable from
contacting with water to avoid electric shock and other dangers. Do not touch it with wet
hands. If there is any fault during charging, disconnect the power plug immediately.
⑥ Do not let the charger or cable come into contact with sharp or hot objects.
⑦ Inspect the charger and charger cable visually at regular intervals, and stop using it in
case of any broken skin or exposed battery core.
⑧ Failure to charge the battery in time after it is exhausted may cause damage to the
battery, since the battery will gradually run out as time goes by and eventually lead to
over-discharge.
After starting up, slide down for about 1M in the power-assisted mode,
and then press the finger accelerator to make the scooter run normally
If the accelerator is driven at a fixed speed for 3 seconds, the sign "
will appear on the dashboard inside, and the scooter will move at a
fixed speed. Even if the accelerator is released, it will not slow down
until the brake stops.
1. Electric brake (and rear disc brake at the same time): when the
scooter is running, press brake handle to achieve the braking effect
2. Rear mudguard mechanical brake: when the scooter is riding, step
on the rear mudguard with one foot to rub the rear wheel, so as to
achieve the braking effect
10 minutes after stopping running without operation, the scooter will
automatically shut down without any other operation
07
"